Home > News > Content

CAM Divider Antirust Processing

Nov 17, 2016

CAM divider special surface processing, make its surface smooth surface brightness and then do antirust processing. So can keep the higher clean remove output set to loosen the output shaft, don't loose the backend gland, so again when load axial position unchanged. Loosen the output shaft after the lock nut and the output of the front end, can remove, together with the set of output shaft, only when the load lock nut, can make the output shaft back to its original position output shaft comprehensive antirust processing, around the shaft flange can do seal, and installation of dust seal intermittent segmentation can do to prevent the dust from the inner, lubricating oil is used do not need to change the semi-solid lubricating oil.